eLoggerTM V4 - the Easiest Way to Monitor your Model's Power System!
New! Whether you’re into Electric Model Planes, Helis, Cars, Boats or other models, you need to know how your electric power system performs under actual operating conditions. The eLogger is the product you need to monitor your LiPo, A123 or any other electric power system.
Here are a few of the enhancements with our new eLogger V4:
- High speed logging at up to 50Hz (increased from 10Hz).
- Sixteen times the logging capacity of the standard eLogger V3. Typically logs all available sensors for about four hours, at 10Hz.
- Voltage logging increased to 80 volts maximum.
The eLogger system comes with everything you need to log, analyze, and graph mAH, Current, Wattage, Voltage and throttle position, right out of the box. And, your eLogger is tremendously expandable, by adding additional sensors (shown below).
Why should I choose the Eagle Tree eLogger?
Some ESC manufacturers are adding data logging to their products. However, these logging capabilities are limited, have very short logging times at high sample rates, and few if any additional sensors are available. While these built-in solutions may "whet your appetite" for data, our eLogger and its incredible array of sensors and powerful software will let you measure virtually anything you will ever need.
Also, investing in logging add-ons that are tied to a particular ESC means that the investment is only good as long as you use that ESC. Eagle Tree telemetry is portable across any ESC brand/model.
Finally, while the ESC manufacturers and others may lose interest in their logging capabilities if they don't sell well, you can rest assured that Eagle Tree will continue to enhance and expand our eLogger with additional features and sensors. Data is all we do!
Here are the key features of the eLogger V4:
Voltage Measurement: approx 5V to 80V
Voltage Resolution: approx 0.02V
Current Measurement: up to 100 Amps peak, (150 Amps peak with the MPRV4-LEADS-150)
Current Resolution: approx 0.02 Amps (0.035 Amps with the MPRV4-LEADS-150)
Current Draw: approx 30 mA with no sensors
Weight: Unit with Integrated Connectors: approx 0.8oz (22 grams), 100 amp unit with Wire Leads: 0.9 oz (25 grams)
Temperature: Dual inputs, 0 degrees F to 424 degrees F (three temperature inputs)
RPM range: approx 100 RPM to 50,000+ RPM
Units of Measure supported: English and Metric
Software Language Support: English, German, Chinese
Measurements: approx 2.25" x 1" x 0.5" (57mm x 28mm x 13mm) including sensor pins
Length of Wires with Wire Lead Version: approx 2.5" (65mm)
Record Time: Varies with sample rate, parameters being recorded, and "activeness" of the model. Anywhere from around 45 minutes to many hours is attainable depending on these settings.